How to make multiple strand bracelets

Things You'll Need Memory wire style: Mark the length with a marker. Begin adding the bugle beads. I clamped on another end cap at the end and cut off the excess leather, just like I did in the first few steps, and then was left with this.

I have two strands here for the purpose of this guide.

how to make multiple strand bracelets

Post a Comment Cancel reply Your email address will not be published. This allows the strands to sit easily within the cone.

Make This: Multi-Strand Bracelet or Necklace

However, the end style is not as elegant as shorter beads. The same method is good for up to 5 strands. Slide on a bead, in this case a 6mm gunmetal round which I have used in the bracelet.

how to make multiple strand bracelets

About This Article. Currently you have JavaScript disabled. Now this next step is a little weird, but I had to do it. Your email address will not be published. Did you try these steps? At this stage, the bracelet should now have spaces between each strand.

I did this because I wanted the beads to stay in place instead of always sliding down to the clasp. Edit Related wikiHows.

I love simple pieces like this, and you explained the DIY so well. By continuing to use our site, you agree to our cookie policy.

how to make multiple strand bracelets

So pretty! Beading , pp. In this Article: Lay the bracelet down, with the first spacer facing downward.

how to make multiple strand bracelets

For the next part, I used the clip of a clipboard to help keep the bracelet in place. Hi Veronica! Trim off any elastic outside of the knot.

how to make multiple strand bracelets